Datalogging ??? issue

Got the first round of logs to check things and it was just a quickie selection of things. Then dumped that log into EA and got the MAF changes. Ran around with those changes and things feel good.

I went to log this past weekend both Sat and Sun. I logged "actuall load" Sat as I could not get any other EA tabs to calc. saying I had selected an improper item to log. I was aiming to get "load X".

Got back and the load X was empty and the reg. load was populated . Sun I logged %load hoping to get load X. Nope it again populated the reg. load in EA... .

I lost my list of items to log I had been going by and cannot find were I got them. Do I need to log both load% and actual load? to get the load X to populate? It is the only thing keeping the calcs from working and I mainly want to get the inj. timing setup.

Thanks for reading a rambling/long post...

Yes wrote the tweecer the same way I always have. This is a new problem I have past datalogs that are fine as far as what is selected/needed.

I have logged both one at a time but each one only populates the load and not loadX. Actual load only populated the load, and load % only populated the load neither populated the loadX.

I know I need loadX but getting it to log in the correct col. is the issue. Do I have to log both to get the loadX to populate?

thanks for the reply.