Edelbrock 750 carb

I'm getting a new motor built up with the following specs.

306
Pro-Flo Wiseco forged pistons
Trickflow stage 1 cam
stock heads with the thermactor bumps ground down
Weiand Stealth intake manifold
Stock headers

Now..with the carb decision. Originally I intended on buying a holley 650 DP but the guy at the shop says he has a edelbrock 750 cfm carb that is practically new and I can have for dirt cheap. He says that edelbrocks arent as bad because the carb is progressive and it may work ok. There is a dyno at the shop so we are gonna throw the eddy on there and see if it runs good and pulls decent numbers

What do you guys think? I know the edelbrock carbs are a pain to tune as well.
 
the edel/carter/weber carb is a breeze to tune. The metering rods and orifice plugs are great. Im gonna tell you its too much carb for that stock head. Been there done that 15 years ago. Had a 302 crate motor, GT40 head, performer rpm intake, b303 cam,carter 750. Ran like dog **** regardless what we did. Changed to the carter 600 and was like night and day. Only had to set high idle and the throttle response all therough the range was crisp and smooth.
 
remember those bad ass max wedge motors from the 60's? What carb did they use? Unless your a serious drag racer or have some serious dollars invested that mandates a serious holley. The edel/carter is an awesome street carb. They also have no chance of leaking like the holley. No mess when changing springs, metering rods etc... People play too much follow the leader
 
n0 0ne is against h0lleys but it seems m0st pe0ple hate edelbr0cks f0r whatever reas0n. if y0u want a d0uble pumper than g0 f0r a h0lley but f0r i ch0se the edelbr0ck because they are little better f0r a street car
 
Dean85GT said:
Soooooooooooo is it not even worth trying the 750? and it seems that everyone is against the holley double pumper. What carb should I go with with mech secondaries and a 4.10 gear.
all thats gonna hapen with that 750 is it's not going to work no matter what you do, then you will be anti-edelbrock when in fact the application is not correct and no fault of the carb. Use a 600 carter/edelbrock which are the same carb. Will work kick ass out of the box short of idle adjustment
 
this site has some good info... http://www.jason.fletcher.net/

plus, you can go to the holley site, and they have a carb calculator that should help you out.

I have a 306 with 10:1 slugs, TFS trackheat heads, TFS stage II cam, eagle crank and rods, 1 5/8 shorties, and im using a holley 650dp. so i believe that 750 is going to be complete overkill for your ride. you wont get good throttle response, and it will be a pain in the ass to warm up on cold mornings. thats the one thing i learned, bigger carbs arent always better, in most cases they are worse.