• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Engine sludge treatment?

  • Thread starter Thread starter 68keyblr
  • Start date Start date Jul 6, 2006

68keyblr

20+ Year Stangneter
Mar 17, 2003
946
20
49
Arizona
Jul 6, 2006
#1
  • Jul 6, 2006
  • #1
OK so my 5.0 has 160k on it now. I'm planning on rebuilding it this fall but need to drive it until then.

I know there is some serious sludge in this engine - the PO apparently wasn't all that meticulous about upkeep on this car and oil changes must have been sporadic at best.

So the question is, should I do a sludge treatment? If so, what should I use? I'm afraid that I'll remove some sludge that is plugging up oil leaks and maybe remove sludge from the rings that's keeping oil consumption down.

So, what say ye?
 

Roland69

Sergeant Tangnet
Sep 17, 2005
2,867
3
58
Port Elgin, Ontario
Jul 6, 2006
#2
  • Jul 6, 2006
  • #2
maby give seafoam a try
 
S

Sicarius428

Active Member
Jan 6, 2004
2,085
5
49
Jul 6, 2006
#3
  • Jul 6, 2006
  • #3
Using a full synthetic will also get rid of the sludge. It's a detergent oil which might clean away some of the sludge which is keeping your seals from leaking. hehe.
Kevin
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Jul 6, 2006
#4
  • Jul 6, 2006
  • #4
Do you think you have a layer of paraffin in the bottom of the sump or something?

If you are going to tear the motor down in one or two OCI's anyhow, I'd wait.

BTW, the ring seal aspect you addressed isnt an issue.

Just MHO.

Good luck.
 

65ShelbyClone

Founding Member
Sep 9, 2000
4,675
38
119
Antelope Valley, SoCal
Jul 6, 2006
#5
  • Jul 6, 2006
  • #5
68keyblr said:
OK so my 5.0 has 160k on it now. I'm planning on rebuilding it this fall but need to drive it until then.

I know there is some serious sludge in this engine - the PO apparently wasn't all that meticulous about upkeep on this car and oil changes must have been sporadic at best.
Click to expand...

You know there is sludge, or do you just suspect? You can do some pretty horible things to modern engines and modern (petroleum)oils without seeing the same breakdown and varnishing as pre-'80s stuff. If the engine runs fine right now, just put some cheap petroleum oil in it and drive until the rebuild.
 

vristang

15 Year Member
Mar 31, 2005
4,933
101
124
Seattle
Jul 6, 2006
#6
  • Jul 6, 2006
  • #6
If the motor is running half way decent now, I too would not mess with it. No point in taking chances before a rebuild.

Changing the oil while it is still hot should help clear some crap out of there.


On a side note...
In talking to some of the "old timers" that I know, I have heard of using 1qt of ATF in an oil change to help clear out the sludge. ATF has some serious cleaners in it.
As I heard it, you are supposed to replace 1qt of oil with ATF, run the car up to temp (but not load the engine, sitting at idle is good), then change the oil and filter. Most of the guys who have done this also recommend changing the oil/filter again, after a short drive.
I am not saying you should do this.
I only bring it up to here what others have to say.
I have tried it in a 2.3t engine I just swapped into my LX. The motor had been sitting with with the head removed for who knows how long. All seems well with that motor so far, but I have only driven ~100 miles since.

jason
 

88 Fox GT

Active Member
Nov 18, 2002
1,674
0
36
Iowa
Jul 6, 2006
#7
  • Jul 6, 2006
  • #7
Personally, I wouldn't even care to mess with it until the rebuild. Unless it's not running right or something.
 
B

BullittAndy

New Member
Nov 9, 2003
139
0
0
Jul 6, 2006
#8
  • Jul 6, 2006
  • #8
I think that there is a higher chance that a sludge treatment will hurt than help.
I've never expereinced a problem after using one (tried it once) but have CREATED two bigger leaks out of smaller leaks from using a seal conditioner (used twice 2 for 2 failure). My dad said he used a seal conditioner on an auto tranny hat was leaking very badly and it slowed the leak considerably.
It seems that when used preventatively these products cause problems but when they are used as a fix they MIGHT work.
Just my 2 cents.
 

68keyblr

20+ Year Stangneter
Mar 17, 2003
946
20
49
Arizona
Jul 6, 2006
#9
  • Jul 6, 2006
  • #9
Good stuff gents - seems like the consus and smart thing to do is leave it since it's running pretty good.
 
You must log in or register to reply here.

Similar threads

Engine Looking for suggestions and or ideas
  • PonyGTrider
  • Aug 25, 2026
  • Fox 5.0 Mustang Tech
Replies
17
Views
744
Fox 5.0 Mustang Tech Sep 7, 2026
PonyGTrider
B
Engine Another no start after washing engine bay
  • bruno
  • Apr 26, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
24
Views
1K
Fox 5.0 Mustang Tech May 7, 2026
AeroCoupe
9
Engine Donor '00 Mountaineer meet '91 Fox
  • 91firecracker
  • May 11, 2026
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
41
Views
1K
Fox 5.0 Mustang Tech May 28, 2026
91firecracker
9
F
Fox 1990 Mustang GT 5.0 A9L – Engine suddenly shuts off but immediately restarts when key turned
  • FishermansFriend
  • Aug 9, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
16
Views
695
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 30, 2026
General karthief
N
Edelbrock 1405 Setup
  • nathantaylor200
  • Nov 4, 2025
  • Classic Mustang Specific Tech
Replies
3
Views
353
Classic Mustang Specific Tech Nov 5, 2025
nathantaylor200
N
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?