I am in the middle of the PI head swap. I have searched the forum a using a couple of different search criteria and am not getting exactly what I want. Auto Zone's torque specs state:
1) Torque, in sequence, to 31 ft/lbs
2) Turn an additional 85 to 95 degrees in sequence
3) loosen all bolts
4) Torque, in sequence, to 31 ft/lbs
5) Turn an additional 85 to 95 degrees in sequence
5) Turn again an additional 85 to 90 degress in sequence
Does this sound right to everyone? Just want to make sure before I throw the cam covers on. Thanks!
1) Torque, in sequence, to 31 ft/lbs
2) Turn an additional 85 to 95 degrees in sequence
3) loosen all bolts
4) Torque, in sequence, to 31 ft/lbs
5) Turn an additional 85 to 95 degrees in sequence
5) Turn again an additional 85 to 90 degress in sequence
Does this sound right to everyone? Just want to make sure before I throw the cam covers on. Thanks!