help with qa1 k-member, a arms, and coilovers install!!!

stonegod85 · Mar 20, 2006

we are about to install the new k-member, a-arms (bushing end), and D&D coilovers with 175lb springs on my 97 VERT...any precautions we should take or any kind of problems we can avoid by buying certain tools ahead of time?
any help would be great...just tired of running into problems that everyone else has and not asking before hand to avoid them.
thanks folks,
Gus

myponyrocks · Mar 20, 2006

make sure your QA1 is square, I forgot to measure mine and it shifted the engine to the side a bit (wich wouldn't have been a problem except for my shaker)

I didn't do A arms when I did mine so can't help you there, but I bet they are easier to deal with than cutting and shaping the stock A arms to fit

jasonh_86 · Mar 20, 2006

http://forums.stangnet.com/showthread.php?t=595299

I'm sure hotmustang331 will chime in on this thread later on, he's already done the full tubular K-member/a-arms/coil-over to his '04 GT

help with qa1 k-member, a arms, and coilovers install!!!

stonegod85

New Member

myponyrocks

I have more billet on the Stang than most women ha

jasonh_86

I

Similar threads

help with qa1 k-member, a arms, and coilovers install!!!

stonegod85

New Member

myponyrocks

I have more billet on the Stang than most women ha

jasonh_86

I

Similar threads

Privacy & Transparency

Privacy & Transparency