• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Injectors

  • Thread starter Thread starter 91ghp5.0
  • Start date Start date Feb 4, 2006

91ghp5.0

Active Member
May 25, 2005
42
0
28
Somewhere
Feb 4, 2006
#1
  • Feb 4, 2006
  • #1
I know this is a totally noob question, but i've always had a misunderstanding on this question. do injectors constantly pump in the amount of gas they are rated at? i wouldnt imagine so, but i was told this was the case once. they ramp up their injection as the computer tells it too (according to boost, etc.), correct? thanks in advance!
 
M

Mr. Potato Head

New Member
Apr 21, 2005
83
0
0
DFW
Feb 4, 2006
#2
  • Feb 4, 2006
  • #2
The computer applies the right amount of voltage to make them flow a certain amount and the rating is their maximum. You have to get a MAF or computer that is scaled to the injector you are using because if you don't and you are using a larger injector than the MAF/comp thinks you are, you will be flowing more fuel at any given voltage which will cause a rich condition all the time and a bad running/bad mileage vehicle.
 

91ghp5.0

Active Member
May 25, 2005
42
0
28
Somewhere
Feb 5, 2006
#3
  • Feb 5, 2006
  • #3
thanks! just wanted a bit of clarification. so if i had a turbo/SC car (or any reason for larger injectors), i could get decent mileage if i kept my foot out of it? thanks again!
 

FastDriver

I was uncomfortably high & wearing a helmet
SN Certified Technician
Sep 5, 2001
6,239
2,945
224
Vass, NC
Feb 5, 2006
#4
  • Feb 5, 2006
  • #4
91ghp5.0 said:
thanks! just wanted a bit of clarification. so if i had a turbo/SC car (or any reason for larger injectors), i could get decent mileage if i kept my foot out of it? thanks again!
Click to expand...

The injectors are not going to be the cause of poor mileage, but if you have a need for them, then chances are you're not going to be worried about getting good mileage.

Oh and to clarify a bit. They are rated at the max duty cycle for a stock pressure of 38-40 psi. If you increase the fuel pressure, 19 lb/hr injectors will flow more than 19 lb/hr.

Chris
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Feb 5, 2006
#5
  • Feb 5, 2006
  • #5
Injector HP ratings: divide flow rating by.5 and multiply the result by the number of injectors. This uses a 100% duty cycle.
Example:
19/.5 = 38, 38 x 8 = 304
24/.5 = 48, 48 x 8 = 384
30/.5 = 60, 60 x 8 = 480

The preferred duty cycle is about 85% maximum, so for a safety factor mulitply the final figure times .85.

Remember that the above ratings are at 39 PSI. Increasing the pressure will effectively increase the flow rating. Example: a 19 lb injector will flow 24 lbs at 63 PSI, and a 24 lb injector will flow 30 lbs at 63 PSI.


Here's where I will lose some of you for lack of understanding:

Increasing the intake manifold pressure above atmosphereic decreases the flow rating by the amount of pressure increase.
Example: injector flows 30 lbs at 39 PSI. You have 10 PSI boost, subtract the 10 PSI boost from the 39 PSI fuel pressure. That means you have 29 PSI pressure at the injector tip. Therefore, a 30 lb injector flows 25 lbs with 39 PSI base fuel pressure and 10 PSI of boost.

Fortunately, the design of the fuel pressure regulator causes pressure to increase as manifold pressure increases. The increase may not be linear though.

See http://users.erols.com/srweiss/ to get the calculators used in these examples.
 

FastDriver

I was uncomfortably high & wearing a helmet
SN Certified Technician
Sep 5, 2001
6,239
2,945
224
Vass, NC
Feb 5, 2006
#6
  • Feb 5, 2006
  • #6
Thanks for the info about boost. Most turbo and blower kits are set up to compensate for the boost with a FMU.

Fortunately, he's not running any boost.

Still, your multiplier isn't too far off from the range ford uses [13.6 (85% duty cycle) vs. 11.84 (74% duty cycle)].

I think it supports the reccomendation for 30 lb injectors.

30 lb injectors: 480 hp * .85 (duty cycle) * .85 (driveline loss) = 347 rwhp.

24 lb injectors: 384 * .85 * .85 = 277 rwhp

Chris
 

Black1987Stang

Active Member
Aug 22, 2004
1,422
0
37
Jersey Shore
Feb 5, 2006
#7
  • Feb 5, 2006
  • #7
Mr. Potato Head said:
The computer applies the right amount of voltage to make them flow a certain amount and the rating is their maximum. You have to get a MAF or computer that is scaled to the injector you are using because if you don't and you are using a larger injector than the MAF/comp thinks you are, you will be flowing more fuel at any given voltage which will cause a rich condition all the time and a bad running/bad mileage vehicle.
Click to expand...


Im pretty sure it doesnt vary the voltage to make them flow a certain amount....It uses 12 volts all the time and the computer increases the injector pulsewidth (how long the injector is energized or opened) to allow more fuel to spray in. Just FYI
 
M

Mr. Potato Head

New Member
Apr 21, 2005
83
0
0
DFW
Feb 5, 2006
#8
  • Feb 5, 2006
  • #8
That's probably what I meant at the time.
 
You must log in or register to reply here.

Similar threads

X
VE Table Not Dialed? Send Me Your Datalog.
  • X-cam34
  • Feb 8, 2026
  • Digital Self-tuning Forum
  • 2 3
Replies
49
Views
2K
Digital Self-tuning Forum May 1, 2026
X-cam34
X
X
Free VE Table Corrections — Drop Your MSQ and a Datalog, I'll Do the Rest
  • X-cam34
  • Apr 12, 2026
  • Digital Self-tuning Forum
  • 2 3
Replies
49
Views
2K
Digital Self-tuning Forum Aug 26, 2026
X-cam34
X
G
Sputtering/misfiring below 2500rpm
  • Godless
  • Sep 14, 2025
  • 2005 - 2014 S-197 Mustang -General/Talk-
Replies
5
Views
562
2005 - 2014 S-197 Mustang -General/Talk- Sep 14, 2025
gkomo
J
Engine No power after idle
  • JustinTilley86
  • Aug 10, 2024
  • Fox 5.0 Mustang Tech
  • 2
Replies
34
Views
3K
Fox 5.0 Mustang Tech Sep 23, 2024
General karthief
B
'03 GT Fuel Pump/Pressure/Delivery Issue
  • Brodach
  • Oct 21, 2025
  • SN95 4.6L Mustang Tech
Replies
8
Views
1K
SN95 4.6L Mustang Tech Oct 31, 2025
gkomo
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?