Installing exhaust..

[Mavrick]

Got all my exhaust pieces... 2.5" catback with flows and bassani tails...

I don't want to weld the tailpipes to the mufflers, but they are identical diameters, can i get another piece of pipe to barely fit overtop of the outlet and tail pipe, and clamp them together? I don't mind welding the flow tubes to the mufflers, but dont want to weld the tailpipes.

 

[155dB5.0]

you will proably have to take the tail pipes to a muffler shop and have them flare the ends were thy go into the muffler, then they will just slide on. Other wise i supose you could put something over them like you said, but the frist way would be better

Darren

 

[88stangmangt]

ya, flare them i wouldnt jimmy clamp them.

 

[Mavrick]

Ok cool, sounds easy enough, hopefully only costs a few dollars.

 

[88stangmangt]

summit sells the peice most likely cheaper than you could get it done for a exhaust shop. 20 or 30 dollars i think it is and you can use a drill.

 

[Michael Yount]

Most parts places sell a little pipe expander that you insert and tighten up with a wrench that will expand a pipe enough to fit over another of the same od. Check out PepBoys/AutoZone and see. Otherwise, most muffler shops will probably slap them on their hydraulic stretcher for what I would guess would be $5 or $10. Be sure to take both pipes with you so they can test fit as they expand.

 

[88stangmangt]

^ thats what i said

 

[Mavrick]

Cool, ill look around for the part tomorrow.

Thanks guys.