Intake troubles :(

I don't think that's the elbow you need? Seen several threads on here regarding the VicJr. Intake.
Try searching for them I found one an has a ton of good info an great pics of members setups. Some have the Edelbrock elbow an some have fab'd up elbows? Also your fuelrails will need to replaced with the edlebrock ones or if you use the factory ones a custom bracket will have to made to hold them down? I've looked into this manifold several times an wanted to swap it into my stang? But this is a short runner intake setup? Meaning you will loss down low HP? But will gain high rpm HP as a trade off? If its a n/a setup I'd spend money else where for more HP? Now if your boosting might be great for your setup? There is always some pros an cons with almost every setup. Again like I said check on here an search for the Edelbrock's Victor Jr. 4.6L Intake Manifold thread an has lot of great info.
Hope it helps you out on your build.

Right on. ? Might have hood clearance issues ? The MMR adaptor plate is the key in making it all come together.
That setup would be awesome for a blown motor?
You will foresure loose low end HP. Goin to a 78mm throttlebody an short runner intake? That is if its N/A?
I have considered that same setup once I put my Novi2000 on.