J-MOD Question

[samishii]

Im currently trying to J-MOD this 4R70W trans valve body here with Shiroelex, and were trying to figure out what size drill bits we need to use, and if possible on what holes cause this 1 picture from TCCOA isn't a very good reference.

http://www.tccoa.com/articles/tranny/shiftybusiness_files/image018.jpg

I have not a clue what ".081" is supposed to be in a drill bit size. ANY help would be greatly apperciated.

 

[sgarlic]

Scroll down further. It says: "Do not follow these hole sizes as they may vary per vehicle application. Refer to the chart provided for hole size information. "

Then, at the very bottom, is a chart, and notes on the hole sizes.

Get a tranny cooler too.