So I had a wrecked 1994 that I pulled 99% of all usable parts off of, and a 1988 I had bought a while back. I'm hooking up a 1994 engine harness to the body, but I'm stuck on a few connectors and at this point I'm thinking I'll have to cut/wire/repin parts of the harness. The problem is, I can't seem to find a good wiring diagram on either one without buying some shop manuals. I'm willing to do so if necessary, but I was hoping maybe someone here had some good info.
Another bad thing about this project is I've not touched it for a few years so I've forgotten a lot of what goes where. I have a 1995 sitting beside it that is dead and I'm looking at it to find proper wiring location so most of the motor is hooked up except for the starter to body/ignition switch, the gauges in the dash, and etc.
This is an engine side (1994) connector. P/N# F2TB-14A459-A. I'm not sure how I'll get this connector working since it has a gasket that is supposed to sandwich up on the inner fender well. I'm thinking I may have to repin/rewire this connector. I can't find the sister connector on the 94 dash wiring I have. It is a 24 pin connector.
This is an engine side (1994) connector. I'm unsure what this goes to although it looks like it runs into the dash as well. This is right beside the 24 pin connector.
This is an engine side (1994) connector. I know where these go, in the passenger side inner fender well. But I don't have a name for them and I think I didn't pull those parts off the donor. What are these called?
More to come in the next post...
Another bad thing about this project is I've not touched it for a few years so I've forgotten a lot of what goes where. I have a 1995 sitting beside it that is dead and I'm looking at it to find proper wiring location so most of the motor is hooked up except for the starter to body/ignition switch, the gauges in the dash, and etc.
This is an engine side (1994) connector. P/N# F2TB-14A459-A. I'm not sure how I'll get this connector working since it has a gasket that is supposed to sandwich up on the inner fender well. I'm thinking I may have to repin/rewire this connector. I can't find the sister connector on the 94 dash wiring I have. It is a 24 pin connector.
This is an engine side (1994) connector. I'm unsure what this goes to although it looks like it runs into the dash as well. This is right beside the 24 pin connector.
This is an engine side (1994) connector. I know where these go, in the passenger side inner fender well. But I don't have a name for them and I think I didn't pull those parts off the donor. What are these called?
More to come in the next post...
Last edited: