One thing to note: I forgot that I've removed the MAT/CLT correction table provided by @a91what so that might be the problem...
I'll try to add it again to my tune and see if it changes something
Ok new data log, the car did stay idling a little bit more, I started the data log way too late.... I confirm the ECT sensor works, it was at 29.4K ohms after idling two times in the garage (it's really cold down there)
The only that changed in my tune is the MAT/CLT compensation table
And I still don't get why it cranks all the way to 3K RPM then goes down, but hey one problem after another right?
Sorry guys, long time no see, been busy with work, life and got myself a 2015 Ecoboost Premium a couple of months ago so not really wanted to work on my old junk
Anyway, today was the day I made it run! I remembered that when putting the engine back together, I had to fight with the installation of the throttle bracket and the throttle cable (which is pretty old and not very "tight" anymore -> to be replaced at some point) so I might have messed up the idle screw
So I went on to start the car, RPM shooting way up still, then went to the idle screw and turned until the RPM went steady... let it run a couple of minutes then disconnected the IAC, let it run, then turned it off, checked the TPS and reset to 0.98 (reset it also in TS).
Disconnected the battery a couple of minutes (even though I don't think it would be necessary with a MicroSquirt?)
Replugged the IAC and restarted the car.
Took a datalog
The thermostat works properly however it seems that when the car is warmed up the idle is getting a little bit more "choppy"... does anyone see something weird with the datalog?
So, I will try to adjust the tune by small increments as I would like to try to drive the car and see if it runs properly...
Right now, I've enabled the "include AFRtarget" under the General Settings but haven't tried to run it yet.
Should I also adjust the injectors' dead time as per this post? https://www.stangnet.com/mustang-fo...tuner-studio-tech-thread.899945/#post-9081430