Are you going to weld in a flat plate to fill what you cut out?Fits pretty damn well now. I can get off both caps pretty easy to fill.
Now to get some ARP hardware
Are you going to weld in a flat plate to fill what you cut out?
True...... can easily be done now or later! The MM brace is pretty high up on my list of next mods!I am. I’m debating if I do that now or keep moving forward and revisit it later
Yep...... I’m in that map you got there. Preparing for the worst.Decided to get outside and cut this out before Snowmaggedon hit. Depending on what forecast you read, anywhere from 18”-35” is coming.
Damn
Anyway, it came out pretty clean. Will try to bolt the brace on and see if it’s enough clearance.
In middle TN. We had this stupid little snow blast today... more snow past couple of years (for us) than usual. Have had a foot or so.. not much to yall, but significant here...Yep...... I’m in that map you got there. Preparing for the worst.
I got the snowblower ready to go...... generator is in the porch with the trickle charger on the battery (my wife and daughter like being able to just turn the key), and everything all gassed up! Not gonna lie...... there’s a part of me that likes all this storm prep sh$t.
bad weather aside, that's a Norman Rockwell moment.Just getting started here. Some good wind
By thursday we will be water ski'n again
Sorry guys.