• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

need help deciding on efi or carb.

  • Thread starter Thread starter hi_po_heads
  • Start date Start date Jan 19, 2004
H

hi_po_heads

New Member
Jan 13, 2003
117
0
0
paragould arkansas
Jan 19, 2004
#1
  • Jan 19, 2004
  • #1
i am planning a 351 swap. i have afr heads and tfs cam. i was wanting a few pros cons of both carb and efi. i know there is few intakes for efi but i was told fuel injection would make more power. open for discussion
 
G

gsxrocky

New Member
Jan 18, 2004
13
0
0
Conroe, TX
Jan 19, 2004
#2
  • Jan 19, 2004
  • #2
It's probably more of a personal preference decision than anything. I like efi. You can get a GT-40 intake off of an old lightning and have the lower ported to match the heads. If you do that I believe you will have to have the computer out of the truck also, but I'm not for sure. Carb would probably be cheaper and build just as much power but efi is real nice. Wish I knew more that could help but good luck w/ the swap.
 
K

ka0tyk

Founding Member
Oct 10, 2001
1,610
0
0
Los Angeles, CA
Jan 19, 2004
#3
  • Jan 19, 2004
  • #3
i vote carb. modifying a carb'ed car is 50x cheaper and produces just as good of results of an EFI car... imagine later on if you try to add like a 50 shot to it... you'd need some larger injectors which alone will run you over $200... aftermarket upper and lower manifolds will run you over $500 for something decent...when you mod the car you'll have to get it professionally tuned and most likely a chip will be in order to modify the stock computer settings, etc etc...which can go over $300 for a tune dyno and chip burn. when you could just change the carb jets for like $20... heh.
 
2

2001droptizzy

New Member
Sep 2, 2003
99
0
0
Humboldt
Jan 19, 2004
#4
  • Jan 19, 2004
  • #4
I say go carb.With the Airgap intake,it makes about 15 more torque at lower R's than the victor.And olnly looses mabey 5 peak HP.

Its cheaper

It makes more torque

Plus the combo looks so so sweet!
 

5.0 HOtrain

Founding Member
May 20, 2001
2,247
0
47
New Hampshire
Jan 19, 2004
#5
  • Jan 19, 2004
  • #5
I went carbed

Just because of money, though the stuff still isnt cheap depending on what you buy. I already had a 303rwhp 302, but couldnt reuse any of my efi stuff for what power level I'm looking at. I would have had to re-buy injectors,maf,tb, and still done the fuel system. FYI, i'm doing a 418 stroker and spent the following: $289 for super victor intake,$300 for msd distributor to fit super victor intake,$705 for 1000cfm demon (not spent yet, next on list), fuel system is going to run around $800-$900, cheaper than efi system, and i'm doing it right. Just a comparo, I'm looking at around 600fwhp, so a less horsepower motor will need smaller parts wich equals smaller cash hemorage. Good luck, you probally wont be upset either route you choose. One more FYI, I was on a budget when I started, take what you're planning on spending and...........................tripple it

Mike.
 

Black 93 Fox

Active Member
Jun 1, 2003
1,995
0
49
Vancouver,Washington
Jan 19, 2004
#6
  • Jan 19, 2004
  • #6
Carb
 
You must log in or register to reply here.

Similar threads

H
Fuel starvation issues, 91 EFI to carb swap. Car dying after 1-3 gallons used. EFI tank, electric fuel pump, bypass regulator. Dual fed carb
  • hassler
  • Oct 11, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
8
Views
728
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Oct 12, 2025
nickyb
9
Forced Induction Prepping for supercharger on non-stock build
  • 91fox427
  • Nov 25, 2025
  • Fox 5.0 Mustang Tech
Replies
7
Views
392
Fox 5.0 Mustang Tech Jan 5, 2026
Qtrhrse23
Q
9
Engine Donor '00 Mountaineer meet '91 Fox
  • 91firecracker
  • May 11, 2026
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
41
Views
752
Fox 5.0 Mustang Tech May 28, 2026
91firecracker
9
Engine Suggestions on an engine rebuild. Stock cam/GT40Ps or aftermarket on both for a fun weekend driver?
  • MadSquirrelTech
  • Apr 28, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
23
Views
695
Fox 5.0 Mustang Tech May 7, 2026
MadSquirrelTech
H
New Built 91 Foxbody electrical failure. Need help
  • hassler
  • Aug 18, 2025
  • Fox 5.0 Mustang Tech
Replies
8
Views
460
Fox 5.0 Mustang Tech Aug 21, 2025
limp
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?