It's done
It looks good
And likely sounds good too
Lets hear it!
I still had the h pipe off my car when I installed the o2s in my lt headers, the end of the sensor sticks out into the stream, uncovered.
the bungs were already installed.
No statement has ever been more accurate..Well ask her, her guess is as good as mine!
Not good stuff....depending on how close that is to the heat...it will fail.Not risking anything here. I actually got a good weld all the way around, but took it a step further and put high heat exhaust epoxy over the weld. I used this stuff to fill the air tube on my old H pipe, and couldn’t get it off with a hammer. Good stuff.
If you needed it,..there was something wrong underneath....if the weld was suspect..time for one of two things.... *hint......High heat Goop ain't one of them.
1. Get yourself a freakin bottle of argon/mix gas, a regulator, solid core wire,..and convert from flux core wire. ( the end result will be so pretty,..you'll thank me)
2. Spend more time behind the trigger.....
I feel like I’ve seen a similar set up like this before from youWell, continued on my exhaust idea today. I used 3” chrome 90 degree bent pipes to start after having an exhaust shop make 90’s around the tank. I had to cut and grind my slash tips, and I think they came out ok for using a sawzall and angle grinder. Lastly, I wrapped most of it to prevent heating the gas tank. Trying to decide if it’s good as is, or if I should fit short 3.5” tips over the existing 3” tips.
I feel like I’ve seen a similar set up like this before from you
Lol . Have you thought about the Saleen style tips?