Power Elbow

[94Blue302GT]

I have a turbo, and a somewhat custom intake, you can search my name for my completed turbo setup.
As you can see, the intake isn't that great.
I was thinking of using a power elbow on a good carb intake, but then how will it bolt up with my sn95 tb? I could do the fox conversion, but I don't have smog, so will it matter all that much? Is it all just the sensor, or is it a totally different setup?
Thanks guys.

 

[84convertablegt]

different throttle cable and bracket, different tps, different iac motor but same plug, different throttle body, but id recommend it for you with a nice fat 80mm throttle body. im assuming you dont have egr or anything so no issue there. the main thing is the throttle cable, u need one from a 86-93 car.

 

[94Blue302GT]

can't you just change the end on the cable and bracket?
Do you still need a different tps and iac, even if the plug is the same? Do i need to swap the sn to the fox stuff then, or take the fox stuff. The cable I can play with, no problem.

 

[84convertablegt]

just use fox stuff, the cables are completely different though. it would take a lot to modify a sn cable vs. just getting a fox cable. the connectiion on a foxbody cable uses a snap on connector and an intergrated spring completely unlike the sn cable.

 

[SWYZ721]

"POWER ELBOW" sounds funny


had too....

 

[94Blue302GT]

hmmm, and i can't use my sn95 one on the elbow? Are they the same bolt pattern?

 

[84convertablegt]

not on a power elbow. the bolt pattern of a fox body tb and a sn95 tb is different. th sn is slightly wider with the bolt holes, but i bet you could widen up the bolt holes and make things work. maybe even keep the sn95 throttle bracket, but i dont know how youd mount it. just an idea.

 

[94Blue302GT]

Ok, so i'd have enough room to slot it for the SN95? That would be cool. As for the bracket, not a problem, i'm pretty good for manufacturing...
Check out my current intake on post number 8.
http://forums.stangnet.com/showthread.php?t=604324
I'm pretty sure i can fab something up...

 

[94Blue302GT]

Oh, and I'd just get a decent flowing lower, and probably port and polish it up real nice. May actually have one in one of my buddies garages..., but then of course i'd have to put in the bungs, which he's done before already and has running on a 351 cleve.