I have the Powerdyne with 9lb pulley and I used to see the guage right up to like 9-10 lbs of boost but now it seems that it doesn't get up that high anymore, like 6 lbs. I checked the belt tension and it seems to be within the specs from the install instructions. Any ideas on why it might not be putting out what it should. I've also noticed that sometimes there seems to be a little hesitation in lower RPMs, that never seemed to be there before. Almost like it is running to rich. Any ideas are appreciated. Thanks in advance.
Powerdyne 9lb Supercharger question.
- Thread starter Aaron'S'tang
- Start date
just4bob50
Active Member
When I first went to the 9lb pulley on mine i wouls easily see 9lbs of boost, and then like yourself over a short period of time I started to notice a loss od boost. Belt tension was fine, all vac. lines where new and I had no leaks. A little later I started having cooling problems and realized that my head gaskets were blown. They were blown out at the water jackets. After I put new gaskets on my boost was back up.
