Progress Thread Project Copper Can
- Thread starter MikeH686
- Start date
florida 50 makes the bezel for the 7.5 holley dash screen to fit right in your stock dash.
So my headers came in finally the other day and I was able to get most of the hot side installed in the car yesterday. This thing is starting to come together nicely.
Got the inter cooler mounted and some of the piping ran from the turbo to the inter cooler. What are yalls thoughts so far?
Finished today with putting the new gauges in the car I think they look great
My OCD is kicking in with the middle gauge not being silver also. I would have to tape it off and paint it. Otherwise, looks like its coming along nicely man.
Hahahha it's all good it's better then it being on one side or another ya know?
Yeah, that is true! I just went back a few pages, and she sure does look sexy with the new wheel set up!
Hey thanks hopefully I'll get this thing Rollin soon before I get flat spots in the tires
Got all the oil feed and manifold ran today ... Used a Upr vacuum manifold for the sensors and feed line.
It's got thread sealant on it that I still have to clean up but it's done at least now onto the drain
It's got thread sealant on it that I still have to clean up but it's done at least now onto the drain
So my brain is not functioning right now. I'm trying to figure out how I wanna finish off the hole for the intake piping going through the fender. Firewall grommet? Exhaust trim ring? Help me out here guys can't find any clear pics of the passageway. @84Ttop @TOOLOW91 @srtthis @RacEoHolic330 any of yous guys know some slick tricks?
If you're referring to the hole in the apron where the pipe goes into the fender well - I have vaccum hose that I split down the middle and put around the edges to finish it off and keep the pipe from getting marred up by it and finish off the edge .
I watched a couple videos. A digital dash is becoming more appealing to me than a bank of aftermarket gauges.
Similar threads
