hey guys,
as mentioned by my earlier thread, Ive been around the block a bit and am welcome to be back in the stang community with you all. Ive done three headswaps on my old car, picked up a used 97 and got a few sets of PI heads sitting around ready to go after years in the shed. I was the first to run reground cams before billet cams come out, and they trashed my motor due to incorrect adjustment with lash caps under the lifters
My question is this, with you mod motor guys, how confident are you with you cams, aftermarket, not PI or non PI guys, but true after market cams that are billet or from houston performance and such that dont use lash caps, and what problems have you or what issues due you anticipate with them, and how many miles. sorry for all the ?'s, and thanks again
Mig
as mentioned by my earlier thread, Ive been around the block a bit and am welcome to be back in the stang community with you all. Ive done three headswaps on my old car, picked up a used 97 and got a few sets of PI heads sitting around ready to go after years in the shed. I was the first to run reground cams before billet cams come out, and they trashed my motor due to incorrect adjustment with lash caps under the lifters
My question is this, with you mod motor guys, how confident are you with you cams, aftermarket, not PI or non PI guys, but true after market cams that are billet or from houston performance and such that dont use lash caps, and what problems have you or what issues due you anticipate with them, and how many miles. sorry for all the ?'s, and thanks again
Mig