I am getting ready to mount my new Autometer gauges. I want all of the factory gauges to work also. I am thinking of running a braided line to the shock tower or somewhere else to gain the needed clearance to mount both of the sending units. My question is, an ideal place space wise and factory sending unit wire wise, would be to make a bracket and mount it to the sway bar mounting bolts. Would this be a bad place to mount these due to any flexing of the body? I really don't want these things falling off and dangling there.
Remote mounting of oil pressure sending units
- Thread starter 9 Deuce GT
- Start date
You'd be doing this for OP only. You have room to mount both with a Tee in the stock location, should you desire.
You dont want to use a Tee for multiple temperature gauge senders.
On 94-95's, I've seen a couple guys run the braided line to the PS bracket, but the accessories are a little different. Others can help ya.
Good luck.
You dont want to use a Tee for multiple temperature gauge senders.
On 94-95's, I've seen a couple guys run the braided line to the PS bracket, but the accessories are a little different. Others can help ya.
Good luck.
795.0pacecar
lover of pudgy polygamists
Im not sure about a cobra intake, but on my TFS intake there were a ton of places to put water temp sending units. I have 2 in mine from when I had both the stock and autometer water temp gauges hooked up.
