• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech

Removing Rear Interior Panels How To?

  • Thread starter Thread starter ddrallstar69
  • Start date Start date Jun 6, 2012
D

ddrallstar69

Member
Apr 26, 2009
43
0
6
Killeen, Texas
Jun 6, 2012
#1
  • Jun 6, 2012
  • #1
I need to remove these in order to install my saleen side scoops but havent got the slightest on how to do it. I dont want to break anything either while trying to "figure it out". If anyone knows how to do this, any help would be appreciated.
 

Killian Korth

Member
Apr 2, 2012
108
2
18
Nebraska
Jun 7, 2012
#2
  • Jun 7, 2012
  • #2
I would assume you would start with the door sills, which you just need to pull on them to get them off.

and from there I would guess the top part above the rear seat would maybe need to come out to get the sides.

from there I couldn't tell you, just look for screws wherever they might be and if there aren't any then pull? I might go take a look at mine and try and help you if I have some time today.
 

94GTCoupe

10 Year Member
May 7, 2006
1,412
92
79
CA
Jun 7, 2012
#3
  • Jun 7, 2012
  • #3
OP,I'm assuming your car is 94-98.
I've never removed the side scoops from a 99-04.

Once you get the rear panels off,the hole for the side scoops should be covered by a small plastic sheet.
Remove that,and the side scoops are attached to the body by 3-10mm nuts.
Just reach into the hole and feel around for them.

http://www.stangnet.com/mustang-forums/threads/how-do-i-take-out-this-interior-trim-piece.856678/
 

jrod2423

Active Member
Aug 15, 2011
176
2
29
Byesville, Ohio
Jun 8, 2012
#4
  • Jun 8, 2012
  • #4
again assuming 94 - 98, so you want to pop the rear seat out and to do that you take a screw driver and push on the white plastic tab and that will release the seat from the latch, then you do it to the other side and pull the seat out. now to get the side scoops out you have to dig through all insulation, and find a hole covered with white plastic take the plastic off and then there will be three nuts holdong the scoop in unscrew them and the scoop will pull right out of the body. now granted im assuming its 94-98 and that your replacing the side scoops below the rear quarter window.
 
You must log in or register to reply here.

Similar threads

How to Route Subframe-Style Intermediate Brake Line?
  • cnorman31
  • Nov 29, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
0
Views
99
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Nov 29, 2025
cnorman31
P
Air Fuel ratio bung location.
  • Praetorious
  • Feb 7, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
39
Views
915
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Feb 11, 2026
Noobz347
9
Engine Donor '00 Mountaineer meet '91 Fox
  • 91firecracker
  • May 11, 2026
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
41
Views
809
Fox 5.0 Mustang Tech May 28, 2026
91firecracker
9
Brakes FOX BRAKES ISSUES
  • PonyGTrider
  • Jan 11, 2026
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
53
Views
2K
Fox 5.0 Mustang Tech Jan 31, 2026
Mustang5L5
E
2007 GT Stalls when lights or a/c turned on
  • ejscarfo
  • Jun 22, 2026
  • 2005 - 2009 Specific Tech
Replies
2
Views
115
2005 - 2009 Specific Tech Jun 29, 2026
ejscarfo
E
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?