setting up for more boost

powernexcess

New Member
Aug 21, 2005
24
0
0
joplin, mo
I have the cheap vortech sc kit that puts out 5-6 psi. I want to put an 7 inch lower pully which ads around 3 psi depending on diffrent situations. My kit did not come with a bypass valve. What are the installation procedures and the best place to get the bypass valve. Just looking for suggestions I'm sure theirs lots of guys that have done this.

Also I'm not seeing any crankpressure issues at the moment, but with more boost what precautions do I need to take. Besides what came in my kit.

thanks for your help!
 
on my engine, my out-of-box SC trim make 5 psi, i added a UPR boostmaster pipe and it make 6 psi.

put the 7 inch crank pulley and it made 9 psi, would spike 10 psi on a cooler day.,

my kit didnt come with a bypass either, what i did.

the upr boost pipe has a big nipple on it for a bypass valve. i didnt want to buy the alum discharge tube, so i went to the hardware store and found a big barb fitting that i could fit a 1 inch heater hose on., i drilled a hole into the bottom of the plastic inlet tube and used some epoxy on the fitting and threaded it in the hole and its very strong. i bought a standard bosch bypass valve off ebay for like 80 bucks (same one the s trim kits use)

i bought like 3 foot of 1 inch rubber hose and plumbed it all up. i had to make a small 180 turn tube out of aluminum. the nipple on the UPR almost faces towards the front of the car, i couldnt get the hose to make such a sharp turn without folding and pinching up.

it worked great, doesnt compressor surge anymore and it drive a bit better. well worth it, espcially if your planning on more boost. i added mine with 5-6 psi and never looked back.

my engine had crankcase pressure issues, i would always blow the dipstick out. i just capped off the PCV valve (making it useless) and ran an open breather, solved my issues.