As some of you know I am purchasing @a91what Eaton m112 he custom put together for the sbf. I figured I’d start a thread showing my progress getting everything ready. I’ll let the pics tell most of the story. I picked up a summit balancer and a trigger wheel and spacer from 64bit tuning. The spacer is cut to properly align the pulley. I discovered however that it’s designed for a stock style balancer and there was no provision on the summit balancer to holt Tge spacers centered. I took the spacer kit that came with the balancer and chucked it up in my lathe to cut it down. Once that was figured out I made a plate I’ll be building off of for the vr sensor, it’s in a rough state now but I’ll trim it down and clean it up before I’m done. Don’t mind the grungy engine and bay, I’ll be addressing that this winter when I pull the engine and repaint and clean up everything.