I bought the seperator from home depot for 12 bucks now I just wanted to make sure it indeed does go between the pcv and intke line. It would also be nice to see some pics of where you guys installed yours and how. Thanks
This could be a different issue though.
Do you have a baffle on the inside of the valve cover? You can tell just by looking down the oil fill neck. If you see the rockers, then you don't have a baffle.
The baffle keeps oil from being thrown up the filler neck, where it can then get into the intake.
A separator would probably still help, but a baffle is a better way to do it.
This could be a different issue though.
Do you have a baffle on the inside of the valve cover? You can tell just by looking down the oil fill neck. If you see the rockers, then you don't have a baffle.
The baffle keeps oil from being thrown up the filler neck, where it can then get into the intake.
A separator would probably still help, but a baffle is a better way to do it.
My engine is still sitting on my engine stand as shown. The top end kit i bought requires you to make a hole in the valve cover for the oil fill kit. I never looked but now that u mention it, I doubt it has the baffle. If it does not have the baffle would u recommend the oil seperator there too, or is it a waste? Heres a pic. Thanks
The separator is a short term solution.
It will fill with oil, and need to be emptied on a regular basis. I was having to dump mine out twice per fuel tank.
The separator will help with the diagnosis, and help get the oil flow under control, but it shouldn't be viewed as a permanent solution.
oh i see now. I never had the problem. Also my setup is brand new and I just wanted to add extra security from gunk. I guess it cant hurt to install it anyhow huh.