throttle body size for this application?

Pinebluffracer

New Member
Jan 25, 2006
33
0
0
I am curious what size tb is best for my current application. There is a gt40 intake, Trick Flow heads, including valve train and new higher compression forged pistons. There is almost 10 : 1 compression. When changing this, do I need to consider changing the mass air flow? Should they be equal in size.
 
Mass Air should be a little bigger than throttle body. I believe the GT40 intake uses a 65mm opening so that should suffice though putting a 70mm shouldn't hurt it but any bigger is useless. I run the GT40's cousin the explorer intake with a 70mm TB. I'm about to upgrade my mass air
 
HoodStrype said:
Mass Air should be a little bigger than throttle body. I believe the GT40 intake uses a 65mm opening so that should suffice though putting a 70mm shouldn't hurt it but any bigger is useless. I run the GT40's cousin the explorer intake with a 70mm TB. I'm about to upgrade my mass air

GT-40 has a 70mm opening. I have pretty much the same setup and Im going for a 70mm TB.
 
There isn't anything drastic with your engine combination (based largely on the E cam specs). Unless more displacement was in the future, 70 would probably be your best bet. Just because you may have big parts that may say "go-fast" a N/A engine is only going to take in what the camshaft allows it to............