Upgrading to 5lug splines

DigitalGhost

New Member
Nov 10, 2006
18
2
0
Portland, OR
I know this is an obnoxious subject but..

I want to put 28 spline moser or strange axles into to back of my 90 lx. I'm thinking of getting cobra disc brakes for the ol' 90 lx but I'm not sure how to go about upgrading the front spindles to 5 lug. The rear is fairly straightforward, but the front is confusing me.

Can I take the front spindles from a sn95 and put them into the fox? How do I go about doing a 5lug upgrade on FRONT only? Please dont link to a thread about this I always get lost in all the different ways to go about it.
 
The front is easier than the rear IMO. You have 2 choices, all depending on which wheels you run and if you want to improve the brakes.

1. Aftermarket wheels or 94-95 17" GT and 94-97 Cobra wheels, along with the 16" wheels will fit the Mark VII/ SVO rotor that fits the stock spindle. No upgrades on brakes.

2. Change to the 94-95 SN 95 spindle and either 94-98 calipers, or the better 99-04 calipers or any of the 13" Cobra combinations for better brakes. You can use the 96-04 spindles, but they will push the wheels out further. All Ford wheels fit these spindles, and of course only 17" or bigger on the Cobra brakes.

You will need to read the websites on upgrades to get all the specifics.
http://sn95brakes.com has the most info. A bit confusing, but if you read it a few dozen times like I did, you will learn about it.
 
I used 94-95 spindles on my cobra convertion, keeps the stock fox track in the front, and used a SN95 rear disc kit in there get from a GT. Got cobra brakes in the front and rear now though, and a 95 cobra booster, ITS BIG! had to hammer the strut tower a little to fit it by and in. Used a 86 t bird master cyl, and did the two port converion up front. gutted the stock porp valve with the ford racing kit amd got a SBCC prop valve in line for the rear brakes. Car stop on a DIME NOW!!!!