Wanna install AutoMeter Oil Press Gauge and keep stock one working???? HERE is how

[SN95StangMan]

I know I'm bringing this thread back from the dead but I'm trying to assemble the fittings for this project. I found all of the fittings on AutoZone's site, except for the 1/8" NPT double male fitting. I can't seem to find it anywhere online either...anyone know a part number or have a link for me? I'd greatly appreciate it

I got my pieces from the local hardware store. Home Depot, Lowes, etc should have that piece, and in a few different lengths

 

[nmcgrawj]

I got my pieces from the local hardware store. Home Depot, Lowes, etc should have that piece, and in a few different lengths

same here. I got all mine from lowes back when i did it. Probably cheaper than autozone too.

 

[95riosnake]

same here. I got all mine from lowes back when i did it. Probably cheaper than autozone too.

Yea I will probably run out to Lowe's this week and pick them up, the parts subtotal was at $22.xx without the male/male fitting from Autozone, that's a lot for a few small fittings.

 

[Bosko5.0]

You also get them from ace hardware.