W WOT Founding Member Nov 26, 2000 2,817 0 46 Regina, Canada Jun 16, 2006 #1 Jun 16, 2006 #1 I was just finishing up the motor and I have major PTV contact. I can't even get the cams to full lift. So I need a degree wheel to dial them in.
I was just finishing up the motor and I have major PTV contact. I can't even get the cams to full lift. So I need a degree wheel to dial them in.
W WOT Founding Member Nov 26, 2000 2,817 0 46 Regina, Canada Jun 16, 2006 #2 Jun 16, 2006 #2 Found the problem, I had a chain slip when I put the tesioner in. Guess that is what happens when you are working on it at 11pm. Now it is good to go, minus headers, and a clutch, and fuel rails. But other then that it is ready to run.
Found the problem, I had a chain slip when I put the tesioner in. Guess that is what happens when you are working on it at 11pm. Now it is good to go, minus headers, and a clutch, and fuel rails. But other then that it is ready to run.
