Search results

  1. KenneBell

    Severe Backfiring and idle issues 92 2.3T

    I have a 92 vert with an 88 turbochicken motor in it, I installed Stingers front mount intercooler and have mandrel bent 3" exhaust from the turbo back with no cat and a straight through magnaflow so there is absolutely no exhaust restriction. Anyways I noticed after installing the front mount...
  2. KenneBell

    Charging Problems with 92 stang

    1992 2.3L stang. The car starts and seems to run fine, randomly the ammeter shows a voltage drop and the lights dim, if I rev it sometimes the ammeter will return to show a charge and stay there for a few moments but will eventually drop down to show a discharge then might cycle back and forth...
  3. KenneBell

    Timing jump!

    88 Turbocoupe motor in my 92 stang and it started pinging when I get on it now. I thought at first it was bad gas, I decided to check my timing. Took the spout out and it is at 10 degrees btdc, I then retarded it with spout out to 7. I then put the spout back in and started the car up, the...
  4. KenneBell

    Turbo Idle Problem

    So the car is a 92 with a complete custom harness by guru joe, using a wet turbo from an xr4ti and an engine from an 86 SVO, and a LA3 computer and stingers front mount and the large vam and injectors with a cone filter on the end of the vam. That is the motor, anyways, when I start the car...
  5. KenneBell

    2005 mustang rims on a 95?

    I picked up a set of 2005 mustang rims for dirt cheap, a local dealership sold them for $100 with tires! Anyways what size spacers should I run to be able to put these rims on my 95 stang? Thanks!
  6. KenneBell

    Fog light install on a 95 vert

    Ok, so I look under the car and there are the brackets and foglight harness wires right next to the slots where the foglights should be. I assume under the center console there is also the connector. Besides the switch is there a fuse or relay missing in the fuse box that I need to install?
  7. KenneBell

    Best Headgaskets for a 95 V6

    Who makes the best headgaskets for a 95 3.8L. I just bought a 95 stang, my first v6 and it has a blown headgasket. I plan on re-surfacing the heads and want to put on a very good set of headgaskets.
  8. KenneBell

    Car idle searches then dies after installation of stinger's FMIC

    Car was running great, I put on stingers front mount and now the car idle searches and eventually after a few seconds just dies. Any ideas? I'm pretty sure all the hoseclamps are tight connecting all the piping. I also disconnected the battery for a day to reset the computer. How long does it...
  9. KenneBell

    How do I increase steering turn in?

    Driving in my friends 95 hardtop that is lowered like mine and with new shocks and struts, same as mine, the steering on his car is very responsive, the steering wheel feels firm and only a small turn of the wheel initiates a hard turn, my steering on my 95 vert feels soft and requires more...
  10. KenneBell

    2.3T compression

    What should good compression be for an 85 SVO mustang be. Did a compression check and got 148, 150,149, 151.
  11. KenneBell

    Anyone ever replace their rubber e-brake trim with a leather boot?

    My rubber trim around the ebrake where it goes into the console is falling apart, anyone ever found a way to put a leather boot on the ebrake without changing the entire console? Thanks
  12. KenneBell

    Will an SVO front swaybar fit on a 92 LX 2.3?

    How can I upgrade my front swaybar? I have an SVO front swaybar but not sure if it will fit. Should I use it or use a GT swaybar?
  13. KenneBell

    Nitto NT555R 315 drag radials, what tire pressure?

    I've got a pair of nitto 315 drag radials, what pressure would you reccomend? I drive around on them so 8psi is probably out of the question but something that I could get decent traction and also take a turn and not worry too much. Thanks
  14. KenneBell

    Exhaust flow question for 2.3T

    I just today put on a 3" downpipe and 3" magnaflow with a turndown and wow the car feels completely differen't the top end feels about twice as fast, lol. However the car resonates because of the turndown and is a bit deafening while cruising. How restrictive would it be If I added a 2.5"...
  15. KenneBell

    88 SVO motor, adjusting boost level

    Stock 85 svo longblock, with 86 svo intake, and xr4ti wet turbo using an 85 SVO compressor housing. I'm using the gillis valve, and watching the boost gauge, as I accelerate hard in first the needle jumps to about 18 for a second then for the rest of the acceleration wiggles at around 16. Is my...
  16. KenneBell

    People with KYB AGX's, What settings work the best for you?

    What are the best settings front and rear that you found for handling, and which settings for drag? Also what springs are you using. Thanks!
  17. KenneBell

    Anyone ever find a strut tower that worked with a Kenne Bell?

    95 stang with kenne bell blower, anybody get a strut tower that fits? maybe a 2 point.
  18. KenneBell

    Very Unhappy With MSD Superconductor Wires!

    This is the second set that have gone bad. I guess the crane ignition and blaster coil reak havoc on the wires, after about 3 months of use the wires begin arcing to any metal they come across basically the whole length of the wire. Anyone else have this problem?
  19. KenneBell

    Who's running Nitto 555R 315 's on their convertible?

    I have Nitto 555R 315's on the back of my 95 vert mounted to a set of 17x10.5 FR500 wheels. I currently have hard top sportlines so the car sits low and when I take a corner the tires rub the inside of the fender. Thinking about getting the pro-kit designed for the convertible to give me more...
  20. KenneBell

    Anyone ever have ther 2.3 Turbo pull hard to 4000 then it stops pulling hard?

    Anyone ever have ther 2.3 Turbo pull hard to 4000 then stop pulling hard? I thought I read somewhere before that many people have had this problem with the 2.3T, that it pulls hard to 4000 RPM then it accellerates almost like a naturally aspirated car, slower. Here is what I have checked so...
Top Bottom
Back
Forums
Menu