edelbrock

Recently got a 1984 5.0L, M VIN. 79,000 miles. Edelbrock Carb, mild cam. No spark from coil to distributor. So far I’ve replaced (in order): battery, ignition control module, ignition coil, & ignition pickup/stator. Confirmed 12v to the ignition coil and that all spark plug wires are...

Hi together, I am new to this great place. I am from Germany and driving a 86GT and 69Mach1. Currently I am thinking about changing from the original EFI intake to an Edelbrock Performer RPM. But I am not quite sure what the result will be. My setup: - Stock cam - GT40 heads - Stock intake -...

Hello All, Recently, I rebuilt my 306 and topped it off with a set of tfs 11r 190's (56cc), and a lightly ported rpmii. I have a custom grind cam from ed curtis spec'd for another build of mine (ported gt40P's/explorer setup) .555/.558 224/220 @.050 111* LSA, and my question is should I be...

I currently have a Fitech efi setup, but I am wanting to get rid of it and go back to a true efi system with fuel rails, etc...What do you guys recommend? Looking for something that isn't too expensive, but will be a performer. I have pulled many gt40 intakes from salvage yards so I know that is...

So I am about to start modifications soon, trying to decide between the Trick Flow Track heat stage 2 kit or piece together an Edelbrock RPM2 and Edelbrock parts mimic the Trick Flow kit. What are your thoughts?

for sale edelbrock sbf rpm alum heads cost $1500 will sell for $950 Jonesville VA 24263

edelbrock 75mm throttle body for sale paid 330 sell for 250 Jonesville, VA 24263

I am building a 393w for my 1995 gt. '94 up 351w block. I am needing help with the camshaft, as i have everything else and i'm wanting to get the motor finished ASAP. 393w Scat rods and crank Mahle forged pistons Edelbrock performer rpm heads(ported) Edelbrock air gap intake (ported) Holley...

Was wondering if anybody is running a ported edlebrock intake. Any noticeable gains? Who ported it? I'm thinking of having mhs port one for me since I'm getting stage 3 heads from them.

Hello all, I am thinking about purchasing a edelbrock 600 cfm carburetor (part number 1406). I'll be bolting it to the stock intake manifold that came with the original ford 302. The original carburetor was a motorcraft 2150, not sure if that helps. Anyways the question is if I need any gaskets...

I bought a set of Used Edelbrock E-Street heads. Model number 5023. I am completely redoing the entire valve train on the heads with the exception of the guide plates and Exhaust valves. I have read where you can not run a hydraulic roller cam with these heads.. any ideas why? If I redo the...