help

Hi I have a 89 mustang Gt convertible that's has high miles but drives well and is extremely fast. A while ago i was driving it and i went to shift it into 2nd gear from 1st and it made a clunk noise and started to rev without me going anywhere like as if i was in neutral. Do you have any...

I got a 2000 mustang gt Whats a good engine? i want to be abe to be fast as a cobra terminator or a 2ss camero 2016 or a 2012 boss I may be unrealistic but I want to be at least fast as a termi tho... If u have any suggestions lmk cause I have 30k n I don't know what to swap my engine with 1...

u

Having toruble with my 95 gt changed transmission already checked sensors and nss was wondering if it has a ground cable if so, located where

Okay, the big issue is I'm not quite sure what is wrong with my car. I have a 2014 GT track pack and I have had it for about 6 months. I drive the car pretty conservatively I think. I mean I play arund in every now and then but by no means foot to floor every second person. Well the other day I...

Just bought a 99 GT and I owned an 03 before so im used to being around these cars,but I have a few issues im stumped about. Such as the theft light stays on 97% of the time and if the key is in the switch the key reminder chime goes off til you crank it whether the doors are open or not but...

I've had my 2005 mustang for close to a year now and never had problems with leaking until this month. There was almost a foot of water on the driver side rear footwell. I read it could be a drain hole and to park my car so the front is slanted down and now there is water in 2 spots on the...

1997 mustang v6 Yesterday after work I had driven about 5 miles and then when I was getting on the highway (current speed 75) and I see my rpm gauge drop instantly to zero, I tap my cluster then take it out of gear to see if its running, its not. I turn the key off then back to the run position...

Going to be removing my passenger side exhaust manifold due to it being cracked completely in half right above where the flange connection is, managed to remove the 6 nuts fastening the manifold to the block , and the top egr bolt, but I can't seem to reach the lower egr bolt or the two bolts...

Hello all, I have a 1970 ford mustang base with a stock 302. I'm thinking about getting some hooker headers (part # 6901HKR) or some shorty hedman headers (part #88400). I'm not sure if I should get the shorty headers or the long tube headers. Both say they are for the 1970 mustang 302 and are...

Hello all, I am thinking about purchasing a edelbrock 600 cfm carburetor (part number 1406). I'll be bolting it to the stock intake manifold that came with the original ford 302. The original carburetor was a motorcraft 2150, not sure if that helps. Anyways the question is if I need any gaskets...

Hey there, as you can tell I'm new to here. I wont bother you with telling you about me, lets get down to the nitty gritty. i have a 1992 BMW 325I sedan, i also have a 1995 SN95.0, with 32k original :) e36 chassis + sn95 5.0 you see where im getting with this? good. Engine is installed...

So this is my third post about this and I haven't fixed it yet. After a clutch job two summers ago I've had this horrible vibration at high speed not rpm dependent just speed dependent. We bought the flywheel from oreilys we changed everything but we did not change the pilot bearing or atleast...

Hello guys, I'm new to this and it's my first time on a forum. I really need some help please... I just bought my first mustang. I'm super excited. It's a 2002 Mustang GT V8. 127k miles. There's an issue with it tho. When the mass air flow censor is plugged in, it idols ROUGH, and runs ROUGH...

Hello all, Im wanting to rebuild my 2 barrel carburetor on my 1970 mustang coupe with a 302-2V. I'm having trouble identifying the carb. On the carb it says it's a motor craft and it looks like the original. But I'm not sure if it's an Autolite 2100 or a Motorcrafr 2150 carb. Do the rebuild...

i have a 99 GT auto vert with about 125k miles. i bought the car in december of last year for dirt cheap (thing was leaking coolant bad, among other things). since then it's pretty much been a continuous project as it is my daily driver. I've been able to tackle most issues with it, but now i'm...

Hello I'm new here first post now about my problem I have a 2000 mustang gt with the 4.6 it has 144.000 I'm having a tick coming from the engine it's a constant tick that gose with the rpms it dose it anytime the engine is on need help don't know if this helps but it dose burn a little oil and...

I have been playing with this Mustang for about a year. It runs great when the weather is warm. When the temp gets down to 50 or less, it refuses to start. It spins over fine. I can raise the hood and let the sun shine on it and it will start after it warms up a bit. I have taken a hair dryer...

What's up stang net peeps?! since the last time I posted here on stang net I've collected two more mustangs. a 94 V6 with an unfinished cobra engine and t5 swap that I have since pulled out and as of today dropped into a 94 mustang gt convertible with an auto trans. I pulled the Cobra out...

Im pretty new to the mustang community, buying my 2004 v6 3.8L mustang just not even 6 months ago. So far I have a catback exhaust system, cool air intake, short throw shifter, stage 2 spec clutch, RAM billet aluminum flywheel, and some raxiom LED halo head lights. I really want to get this...