Progress Thread 1965 Coupe To Fast Back Conversion ,number ...i Forget !
- Thread starter horse sence
- Start date
The driver side door frame is built ,i have setting place but i have to do the outer wheel tub and the inner rear door post before it can be clamped in place to stay
The wheel tubs are ready to go in. Weld everything but the lower rear tail to the trunk drop off ,you will thank me when you put on the new quarter
Both door frames are welded on ,but i have a small bit of welding to do on the inner rear posts . The roof brace is in and the trunk divider is welded to the rear frame work . The rain gutters are next .
You would be surprised how fast they go back together ,everything is new so you dont have to fight with anything .
I did have to brace the passenger door frame to keep it in line though ,first time i ever had to use a brace
I did have to brace the passenger door frame to keep it in line though ,first time i ever had to use a brace
Ha ,a hot breeze blows through that could roast hot dogs !
Got it welded up ,that was fun in this heat .
The quarters will be next ,maybe this weekend ,but it is supposed to be 107 ,so maybe not !
Got it welded up ,that was fun in this heat .
The quarters will be next ,maybe this weekend ,but it is supposed to be 107 ,so maybe not !
Drilled the plug weld holes in the quarter and welded them up ,i didnt weld the quarter to the tail panel just yet, but i did set the back window opening and welded that
Last edited:
The roof was next ,dynacorn cut the lip at the front window opening almost 1 /4 inch short but all the openings were good ,i had just enough room for plug welds
Similar threads
