Thats depressing, all that chevy stuff in a ford block.
I say drop in a coyote and be done with it
Sometimes bellybuttons can look pretty nice.
Dodge parts. That's what it needs.
All Fords from 1905 to 1913 had a large percentage of Dodge parts in them.
Like the 1905-1908 6 cylinder Model K. Lookes like it had
1. an Independent Runner Intake,
2. external pipe cooling system, sleeved cylinders,
3. and is that EDIS down in the brass pandoras box...?
Hey its practically the Monsta's engine, right?
I remember the article by the photo.....it was part of a survey conducted by a Navel Surgeon.....
It seems to be a word frequently applied to the Irish, with their established love of the high-spirited and artful ploy, and in fact may well come from the ancient Irish word sionnach, meaning "fox" — a traditionally sly beast.
What were we talking about again? Mike got Billy Goat knees installed?
IMHO, I think "Noobz" is the accepted term for all you guys.
A Stangnet term. 1. Something or someone that is a bit suspicious, doesn't seem quite right. Doesn't seem the real deal. 2. Slack, broken, worthless or useless. 3. Not very appealing.
4. "he dodged the issue"; "she skirted the problem"; "they tend to evade their responsibilities"; "he evaded the questions skillfully".
5. Dodgem. A small low-powered electrically powered vehicle ...
......
At least I think this looks good albeit that the crank radius is a little tight.
.......
Lavron said:I was messing with comparing the rods today and pulled one of the rod bearings out, pretty sure they are the original.
And I know this is a crude way to show the difference in length but I don't have a way to press the wrist pin out, so the "precision" ruler is sitting against the pin and then you can see on the other one I was measuring from edge to edge on the holes.
A bit of difference in length, hopefully I have solved my quench issues if I can keep from getting the CR too high.
I also was checking to see if the rod bolts were the same because I am wanting to have ARP bolts installed and I wasn't sure what to order, looks like regular SBF bolts will work, have to see if I can find a 6cyl set so I don't have to buy the 4 extra, expensive bolts - I think we know why that isI switched the rod caps and nuts as suggested here to see if they were a match, I was pretty confident they would but better safe than sorry.
Everything looks good for ignition!
It could've been...Every rod cap bottom bearing looked like that,....every top bearing was shiny at the top of the bearing in the top most part of the radius..( I just assumed that it was from boost pushing down so hard on the rod..)This was No5 ?
]
Is that why I keep holding on to decades old computer parts? Nostalgia at its ultimate height!.Im pretty much at the point where Id rather just throw stuff away than sell it. Not worth the BS that comes along with it anymore.
Every day.@CarMichael Angelo
Do you have any tinges of regret for leaving you 60 gallon air compressor behind?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?