OK...learning the hard way that Mark 7 conversion wasn't the best way to go, but that is what came on the car...along with a UPR K-MEMBER, A-arms and coilovers. I bought some 17x9 Cobra R replicas (23MM OFFSET) and learned the rim scrapes the coilover in the front. Only thing that helped was a 5/16 spacer and that doesn't leave any room for tire bulge. Additionally...looks like the rim is at least 1/2 to 1 inch outside the fender well (looks like crap). My question is.......do the SN95 spindles bring the wheel hub inside the wheel well any more than the Mark 7s? I know it will effect the dust cap and allow a wider range of rims....I just need to get these #@!%!$ 17x9s under the front fender without rubbing the coilover. I am very close to throwing in the towel and ordering 17x8s with 5.24 backspacing fromn AFS....but since I already have the rims...was hoping someone knew the answer to my question. Would rather spend the mony on some new tires. Thanks guys! Ron