once you are within 3% of target, you can just let the small things go you will kill yourself trying to get it perfect.
What’s the fun in that? Lol ya I’m definitely there. I had one small boosted area I wanted slightly richer and I left the rest alone. Car is a blast to drive!once you are within 3% of target, you can just let the small things go you will kill yourself trying to get it perfect.
You might wanna get a second opinion on that plan. Water dont like to be compressed like air does.Some ideas on this ever evolving project. for starters I'm going to add an additional meth nozzle before the blower to cool the blower itself and hopefully increase boost by helping seal the rotors a bit. I ordered a 1.5gph nozzle for this. I'm also thinking about a bigger intake tube, oval 5"x2.5" that'll go over the top of the blower and angle over to the area where the A/c would be on cars equiped. Then use an oval TB. Gotta check hood clearances etc this would probably be a project for next winter but i can get started mocking things up and gathering parts. Who knows maybe I'll get it done sooner...
It’s actually quite common. Prometh actually suggested you do that. I won’t be putting all the meth through it. Most will still be sprayed underneath it.You might wanna get a second opinion on that plan. Water dont like to be compressed like air does.
MOF,..water dont like to be compressed at all.
Before and after. Small 1.5 nozzle before. I suppose I could block off the nozzle under the blower and order a 10gph and swap out the 1.5 and see what happens. Not sure I have the motivation to pull the blower to swap out that nozzle though.Are you only spraying before the blower now or both?
The pressure increase was expected, you may try swapping the nozzles and spraying the majority ahead of the blower.