89 lx head swap

check

New Member
Dec 2, 2004
6
0
0
need alittle info 89lx rebuilt stock bottom end ive got world product heads the jrs flow 185 1.60/1.94 valvles 58 cc anyway what would the best cam be injector size and intake to use i wont be driveing everyday i will be using 4.10 gears with 5 speed trans and will i need to have ecu reprogramed
thanks your help
 
You won't need anything tuned, but it wouldn't hurt. Many, including myself, drive around for years with no tune...

A custom cam is the best way to go, most of the cams run around the $275-$350 range. I would prefer Ed Curtis at www.flowtechinduction.com or Buddy Rawls at [email protected].

A TFS1 would be fine though...

I can't see spending that much money on a cam for a stock bottom end motor. The only way i would spend that much is if i was running a turbo, supercharger, stroker, or spray. TFS 1 cam is only $160.
 
I can't see spending that much money on a cam for a stock bottom end motor. The only way i would spend that much is if i was running a turbo, supercharger, stroker, or spray. TFS 1 cam is only $160.

I'd pay the extra $160 bucks to get better driveability, better power, better vacuum, and a better matching piece with the professional advice.

The cam is very important to the engine.

If spending the extra $160 isn't worth that to you, that is fine by me...it is just not the choice I make.

I don't think just because your engine doesn't have extra stroke, that you should cheap on a cam.

I don't find anything wrong with the TFS1, it is a great bang for the buck and well proven.
 
I'd pay the extra $160 bucks to get better driveability, better power, better vacuum, and a better matching piece with the professional advice.

The cam is very important to the engine.

If spending the extra $160 isn't worth that to you, that is fine by me...it is just not the choice I make.

I don't think just because your engine doesn't have extra stroke, that you should cheap on a cam.

I don't find anything wrong with the TFS1, it is a great bang for the buck and well proven.

Well to each his own. But IMO i can't see spending that much on a cam. There are way to many cams out there to have one made for a motor with only a intake and heads.