98 build up has started

Well the parts have started coming in.
my 98 cobra has been parked since last fall and now it's time to breath some life back in to her > The M&M rear lowers are on the car .
the Alum block and crank are at the machine shop .
Yesterday the headers gaskets , JLT cold air intake and the Fuel PSI guage came in .The 255 fuel pump and adjustable rear uppers came in today as well as the AJE Racing tubular K-member.
Tomorrow the B&M Ripper shifter ,M&M subframes ,the off set rack bushings ,and the Steeda X2 ball joints will be here .
Man this week-end if it's nice out I'm going to turn some wrenchs

I have yet to actually buy any real motor parts

I got the 255 lph pump in yesterday only got to work on it for a few hours>
today is a diffrent story > I got the K member in with the STEEDA X-2 Ball joints and got it back on the ground very sweet so much more room under the motor area it's not funny > and really wasn't hard to do at all >> I also installed the rack off set bushing's while I was there > tomorrow i start the rear upper arms and might start pulling the rear apart to put the 3:73's in it