I am trying to get my mustang back on the road. All I want to do is get it driving. Right now I have the C-4 transmission sitting in the garage with a stock converter. When I rebuilt my engine I put in a high performance camshaft thats suppose to be good in the 2000-5500 range. Could I use the stock converter? I am not looking to have it perform at it's best just to drive it. If I did would I harm anything?
Also I am running the 2bbl and stock manifolds with this setup, whats the worst that can happen when I run this setup with a camshaft like this and compression of about 10:1 besides loss in power.
(Camshaft is Crane 278H, 222 duration @.050 and .498 inches of lift for both valves)
Also I am running the 2bbl and stock manifolds with this setup, whats the worst that can happen when I run this setup with a camshaft like this and compression of about 10:1 besides loss in power.
(Camshaft is Crane 278H, 222 duration @.050 and .498 inches of lift for both valves)