• Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech

Got the Stang back on the road But ive got some problems

  • Thread starter Thread starter stephen4785
  • Start date Start date Feb 8, 2004

stephen4785

New Member
Dec 14, 2003
321
0
0
Fort Worth Texas
Feb 8, 2004
#1
  • Feb 8, 2004
  • #1
Well i got my 65 coupe back on the road yesterday.Went out to drive it last night and it was a quart and a half low on tranny fluid(ATF).theres no leaks anywhere on the outside of it so I guess its the tranny cooler.BUt not quite sure because soon as I put the fluid in it started smoking out the pipes like a freight train.Oh and the tmimng chain cover is leaking again.I just finished putting the new gaskets on it Friday.Does anyone have any idea why this stuff has happened. The only conclusion I can come up with is that the tranny fluid might be coming from the vacum tube from the tranny to the carb port.Why I have no clue.The fluid leak is a mystery also.Im gonna get a new radiator cap for it to make sure thats not the problem.Someone told me that the timing chaion cover leaks are very common on the stangs and there almost impossible to fix because something wrong with the cover.Its not running right at all.It doesnt sound like its missing at speed but at idle it mises on cyl 4&7.Its got a mallory ignition/dist on it.well thanks for any help.
 

jikelly

20+ Year Stangneter
Jul 9, 2003
872
53
99
Lubbock Tx
Feb 8, 2004
#2
  • Feb 8, 2004
  • #2
How did it run before you added the fluid? Is this a rebuild or just a gasket kit install?
 

stephen4785

New Member
Dec 14, 2003
321
0
0
Fort Worth Texas
Feb 8, 2004
#3
  • Feb 8, 2004
  • #3
Well i just bought the car from a friend of a friend and he said that he had just got the motor rebuilt.When i got the car the motor was already out of it and i had to install it.I replaced the gaskets because there was a leak between the timing chain cover and the block.Yeah everytime I refill the tranny it smokes really bad. I pulled the vacum hose from the back of the carb and theres a little tranny fluid in it.
 

jikelly

20+ Year Stangneter
Jul 9, 2003
872
53
99
Lubbock Tx
Feb 8, 2004
#4
  • Feb 8, 2004
  • #4
That sucks. Sorry to hear that, it sounds like there is a serious problem with the tranny or at least the vacum modulator. Luckly the modulator is actually not that hard to change out and you can pick one up for like 20 something bucks from autozone. As far as the timing chain cover I assume that you are loosing water from the cooling system. I would think that a new gasket would solve that one. On my stang I had a leak at the water pump. It was a bolt hole that was leaking. I solved it with good old RTV. Is there any posibility of there being a crack in the timing chain cover? Can you actually see where the water is coming out?
 

stephen4785

New Member
Dec 14, 2003
321
0
0
Fort Worth Texas
Feb 8, 2004
#5
  • Feb 8, 2004
  • #5
no its just seeping out from the mating surfaces I think.I think Im just gonna run it up to my in laws shop and take it all back off and check it out.Its about the only thing i think of. And for the tranny .I just took off the vacum modulator.Im thinking thats all it.It not suppost to have tranny fluid coming out of it.Butt ill try it and hopefully thats all it is.
 
C

C0V3R

Member
Feb 14, 2003
524
0
16
Australia
Feb 9, 2004
#6
  • Feb 9, 2004
  • #6
Easy way to find out would be adding the ATF, and disconnecting the transmission vacuum line. If it doesnt burn up then theres probably a leak in the vacuum modulator
 

stephen4785

New Member
Dec 14, 2003
321
0
0
Fort Worth Texas
Feb 10, 2004
#7
  • Feb 10, 2004
  • #7
I removed the modulator and it was bad.Replaced it.ran the car for awhile and drove it.It doesnt use tranny fluid but still smokes enough to where you can tell where Iv been driving.
 
D

D.Hearne

New Member
Sep 29, 2000
11,730
6
0
south louisiana
Feb 10, 2004
#8
  • Feb 10, 2004
  • #8
Sounds to me like you've maybe got too much oil in the transmission. Where is your timing cover leaking? Is it from the front seal? If it is, then you may need to get the tool to center the timing cover before bolting it down. Ford fixed the centering problem on the later covers by installing dowels in a couple of the timing cover bolt bosses in the block. Or your balancer may be worn to where the seal doesn't contact it. Felpro makes a kit with a sleeve to fix this.
 

stephen4785

New Member
Dec 14, 2003
321
0
0
Fort Worth Texas
Feb 11, 2004
#9
  • Feb 11, 2004
  • #9
well I found out that the reason its smoking is probably from two cylinders.I only get 55-60 psi on both of them.Guess Ill tear it down and find out whats wrong.
 
You must log in or register to reply here.

Similar threads

M
I really wasn't expecting this....... First time Mustang owner.......
  • Mikedd969
  • Nov 27, 2019
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
6
Views
3K
1996 - 2004 SN95 Mustang -General/Talk- Nov 28, 2019
Mikedd969
M
Car put me down......again. What now?
  • Wayne Waldrep
  • Sep 10, 2019
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
38
Views
7K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Sep 18, 2023
Mindseye007
Getting my car decent. Looking for thoughts on this long list.
  • Wayne Waldrep
  • Jun 10, 2019
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2 3
Replies
50
Views
10K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Nov 17, 2020
Mustang5L5
S
Drivetrain New To Stangs, Need Help Diagnosing Aod Problem!
  • Skyler Barnes
  • Jun 14, 2013
  • 1994 - 1995 Specific Tech
Replies
10
Views
1K
1994 - 1995 Specific Tech Jun 16, 2013
revhead347
Progress Thread Prime's 87 T-top Gt
  • Prime Lord
  • Apr 14, 2014
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 13 14 15
Replies
295
Views
17K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Nov 22, 2025
Prime Lord
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?