Help on Cam

[mackey]

Well as my dad goes off to Asia this week I am going to be left alone with a set of new heads cam and intake. He is going to be gone for a good 15 days so I will not be able to have his help with this project. What is your advice for doing this? My main concern is installing the cam. I have purchased the trickflow kit and it will arrive at the beginning of this week. How hard is it to install the cam. Can you give me some advice and a step by step walkthrough for it? What other concerns should I have? I am going to be doing a H/C/I and harmonic balancer. Any advice will help, I have watched and helped my dad and this will probably be my first time doing it alone. What do I have to worry about with degreeing the cam and stuff like that. Any info is helpful. Thanks!

-Steve Mackey

 

[mackey]

Oh and how do i get the cam out without pulling the engine. Is it possible *94 gt

 

[Rick 91GT]

To get the cam out of the motor you will need to remove the radiator, fan and A/C condensor out of your way so you can slide it out.

For installation instructions check out http://www.cranecams.com/?show=technicalHelp&PHPSESSID=51102c7a155497b6047117c3c86cea5f look under installation instructions, it also has ones for the valvetrain. I also suggest you invest in a Chilton or Hanynes manual it will also help guide you through everything and give you the required torque specs.