i'm having the worst luck lately

Shirley

Founding Member
Nov 14, 2001
112
0
0
Phoenix, AZ
Last night my 15 year old P.O.S. driveshaft broke. Had to get the car towed home. Just ordered a FMS aluminum from summit. Before this happened I installed my Lakewood 50/50 rear shocks. The shocks were about a 1/2''-1'' too short for the nut to thread onto the upper mount, so I jacked up the rear like a quarter crank on each side to move the rod further up so the nut could thread , and it worked. My question is, did I somehow screw with the angle of the d/s by jacking up the axle a little ?, or are Lakewood shocks just that good? The shocks I pulled out looked like they were from 1991. And also, how tight do you have to torque the d/s flange bolts to? thanks
 
dunno about the shocks question, but really i dont think it made a difference

what were you doing to break your driveshaft (u-joints im assuming)?? it took that guy on pinks a 4000 rpm launch on slicks and 275 shot of nitrous off the launch to break his stock d/s... dunno how old it was though :D
 
If a U-joint had enough slop, that could allow the DS to come apart. Otherwise I am with Euphoric on breaking it.

The flange bolts are 12 mm 12 point. They get torqued to around 100 ft lb. If you reuse them, apply threadlock. Or you can get new ones. Shakerhood just very very recently posted the part number for the new bolts from Ford.

You will lose a little trans fluid too, so have some extra on hand.

Dont run Lakewoods.

Good luck.
 
yes the rear u joint broke. I had to walk about a block to recover my driveshaft off the middle of the road. For about a week before this happened, I have been hearing a whining noise from the rear, and there has been a slight clunk sound when I engage reverse, or when I put it into park. Why shouldn't I run the lakewoods hissin?
 
Shirley said:
Why shouldn't I run the lakewoods hissin?
Whoops, my apologies. I meant to say that I dont have feedback about the Lakewood-damper installation since I dont run lakewoods. I guess the rest of the statement would have helped. Sorry. :bang: I didnt even see that it read so incorrectly as I sent it. FWIW, I hear they are very nice. :nice:
 
Shirley said:
there has been a slight clunk sound when I engage reverse, or when I put it into park.

This should have been a sign that you needed to check out your u-joints before this happened. And no, you didn't screw up the pinion angle; your control arms determine that.
 
you really wouldn't use air tools to torque them anyway......a torque wrench with the appropriate socket would work.......

or, lol, clean the bolts, put thread locker on them, put a 12mm wrench on them and when it's tight smack the wrench with a hammer....this will work long enough till you can get a wrench to torque it with, but make sure you re check it the right way at some point .......they do have a nasty habit of losening up......
 
Have your gym-rat friend come help you. :nice:

FWIW, I use a 3/8" ratchet, short extension and socket on those bolts. I wouldnt risk impact, as TW said, since those bolt heads dont make me feel warm and fuzzy - it would suck to be not quite lined up and strip one.

Seriously, you could also use your foot to push the wrench.

Good luck.