INjector SIze HElp

Hey guys got a question for ya bout injectors? I came across a deal for some 32lb injectors with matching pmas. I need to know if they will be suitable for my combo.

Right now i have a set of 24's and i think they will be to small for the new build. Tell me what you think

mexican block
347 stroker
edel. alum heads 1.9 and 1.6
dont remember cam specs somewhere in the 590in/600 ex range
edel. upper and lower
bbk adj fuel reg
255 fuel pump
edel. 100 maybe 125 shot nitrous , but its a wet kit, so it doesnt rely on injectors, supply's it own fuel.
Lontbubes
built aod
I think thats it.


whatchya think?:shrug:
 
Injector HP ratings: divide flow rating by.5 and multiply the result by the number of injectors. This uses a 100% duty cycle. These ratings are for naturally aspirated engines.

Example:
19/.5 = 38, 38 x 8 = 304 HP
24/.5 = 48, 48 x 8 = 384 HP
30/.5 = 60, 60 x 8 = 480 HP

The preferred duty cycle is about 85% maximum, so for a safety factor multiply the final figure times .85.

304 HP x .85 = 258 HP
385 HP x .85 = 326 HP
480 HP x .85 = 408 HP

Remember that the above ratings are at 39 PSI. Increasing the pressure will effectively increase the flow rating. Example: a 19 lb injector will flow 24 lbs at 63 PSI, and a 24 lb injector will flow 30 lbs at 63 PSI.

See http://users.erols.com/srweiss/ to get the calculators used in these examples.

Here's the duty cycle explanation. Duty cycle is how much of the time the intake is open the injectors are turned on. The 85% figure means that for 85% of the time the intake valve is open, the injectors are spraying. The idea is that you want some percentage of the duty cycle left over so that you have some room to grow the process.

If you are at 100% and you need more fuel, all you can do is turn up the fuel pressure. That means the whole fuel curve from idle to WOT is affected. Maybe you are already too rich at idle, and turning up the fuel pressure makes it worse. If you had some injector duty cycle left to play with, a custom tune could use that where it is needed. That would not over richen the whole range from idle to WOT.
 
If you look carefully at the figures I posted ,you will find that 24 lb injectors will be fine.

It is very unlikely you will make more than 408 HP on a street/strip tuned 347 without a power adder. Since your NO2 has its own fuel nozzle and does not use the injectors to supply fuel, it does not require bigger injectors.
 
You need the 30's. Thats what i'm running on my 347 ( a bit more wilder than yours) and they're near maxed out up top :) I didn't find that out by doing a math equation, I found out in the real world looking at the duty cycle on my PMS :D