hopefully it will go without incident. i'll look crazy out in my parking lot at work with the hood up, but they are kinda used to me like that by now.
the nice thing about these injectors is that they have been flow tested (4 at 30.1 lbs/hr, 1 at 30.2, and 3 at 30.0), so i know just what value to enter in my calibration, so the tuning should be very straightforward for this. it will also allow me to make that parameter a constant. it's always better if there is one less variable in the equation. i'm going to set my cal at 30.1 and then i can forget that part of the tune.
i was considering the option of getting a matched set, where they all flow exactly the same amount, but that was almost twice as expensive, and this will be fine for my purposes.
wish me luck ... if things go as planned, i will have some 42# injectors up for grabs today. if anyone is interested in them, pm me
the nice thing about these injectors is that they have been flow tested (4 at 30.1 lbs/hr, 1 at 30.2, and 3 at 30.0), so i know just what value to enter in my calibration, so the tuning should be very straightforward for this. it will also allow me to make that parameter a constant. it's always better if there is one less variable in the equation. i'm going to set my cal at 30.1 and then i can forget that part of the tune.
i was considering the option of getting a matched set, where they all flow exactly the same amount, but that was almost twice as expensive, and this will be fine for my purposes.
wish me luck ... if things go as planned, i will have some 42# injectors up for grabs today. if anyone is interested in them, pm me