The box is glassed to the hood mold, i have to finish the box ,flip the whole thing over ,and it weighs about 180 lbs. ,then trim the mold and pop the hood out
Cut holes for clamping ,flipped it over and somewhat trimmed the flange . The hood just about fell out ! Came out perfect except for a couple of chips at the end of the scoops i will have to fix but i am very happy ! And the ram air chamber made it in today !
And the steel hood has not one speck of damage !
Repairing the chips around the scoops this morning ,they couldnt chip at the top where it would be no problem ,oh well ,it isnt much to fix at least . The mold release peeled out of the mold in a sheet leaving a nice shinny grey surface ,i will still block sand with 1000 ,up to 2000 them buff the surface
Other than a lot of block sanding this came out pretty easy ,except for a couple of dings and a couple of pits . I will sand them out today and get the final primer on it ,tomorrow a whole bunch of wet sanding and i am ready to make the under brace mold