supporting parts needed to run s/c

[Finally a 5.0]

i have a powerdyn bd-11 s/c that i am waiting to put on. my car is stock with just bolt ons. trying to figure out what i am gonna need to run 6# and 9# safely. i'm assuming i wouldnt be much over 300rwhp if that so i wasnt sure if i would need new injectors, fuel pump, and all that. it has an fmu with it but i would rather get a tune for it, or at least get it on a wideband to check on a/f. any advice would be great.

 

[onlyme]

s/c

well injectors 36-42lb ,mass air meter,255 lph fuelpump, and a good tune

 

[Finally a 5.0]

well injectors 36-42lb ,mass air meter,255 lph fuelpump, and a good tune

you think i would need that big of injectors and a new mass air? i figured the fuel pump and a tune, but i thought the 19#ers were maxed out at 300.

 

[Trick95]

NA motors can get by with smaller injectors at the 300 hp mark. With forced induction, you need 36-42#ers.

 

[Finally a 5.0]

damn, i guess i gotta add those to my list. anything else?