I just bought a Typhoon Intake. Its on its way... I have read over and over again that the Typhoon and the RPM are virtually the same. I want to know if I can use the phenolic spacer kit for an Edelbrock Performer RPM with the Typhoon.
Good Article on the Typhoon:
http://www.fordmuscle.com/archives/2003/12/efiintake/index.shtml
1989 Grand Marquis 302 Block
Bored .030 over
Sterling Hypereutectic Pistons
1969 351W Heads (30 hours of hand porting)
60cc combustion chambers machined to 50cc
~10.5:1 Compression Ratio
Ford Racing F-303 Cam
Sealed Power Hardened Pushrods
Sealed Power Valve Springs
TRW Guideplates
Clevite Studs (For Roller Rockers)
Cloyes Double-Roller Timing Chain
Harland Sharp 1.6 Ratio Roller Rockers
A9L Mass Air Computer
70MM Cobra MAF
Chromed Cold Air Intake Kit
24lb/hr Fuel Injectors
3.55 Posi Rearend
Mac Equal-Length Shorties
Mac Off-Road H-Pipe with Flowmasters
3" Cowl Hood
Good Article on the Typhoon:
http://www.fordmuscle.com/archives/2003/12/efiintake/index.shtml
1989 Grand Marquis 302 Block
Bored .030 over
Sterling Hypereutectic Pistons
1969 351W Heads (30 hours of hand porting)
60cc combustion chambers machined to 50cc
~10.5:1 Compression Ratio
Ford Racing F-303 Cam
Sealed Power Hardened Pushrods
Sealed Power Valve Springs
TRW Guideplates
Clevite Studs (For Roller Rockers)
Cloyes Double-Roller Timing Chain
Harland Sharp 1.6 Ratio Roller Rockers
A9L Mass Air Computer
70MM Cobra MAF
Chromed Cold Air Intake Kit
24lb/hr Fuel Injectors
3.55 Posi Rearend
Mac Equal-Length Shorties
Mac Off-Road H-Pipe with Flowmasters
3" Cowl Hood