transmission

  1. Giovannylara

    Transmission Issues With New Foxbody

    Hello guys, new to the forum. Expect to see a lot of me here from now on lol. I just recently bought a 88 foxbody. It's a lx vert with a 5.0. It's got 75,000 original miles on it and most of the car had been left stock.I've been having some issues with it. I believe it is a torque converter...
  2. F

    Need Help/suggestions

    Hi I have a 89 mustang Gt convertible that's has high miles but drives well and is extremely fast. A while ago i was driving it and i went to shift it into 2nd gear from 1st and it made a clunk noise and started to rev without me going anywhere like as if i was in neutral. Do you have any...
  3. I

    Auto To Stick Conversion (with A Donor Car)

    so here's the story. I've got one smashed up '05 GT (auto) in my garage. I was already planning on buying a donor car, and the one I was looking at was a manual. What would it take to swap the trans? Would I even have all of the parts I would need? I know people say it isn't worth it, but I've...
  4. T

    Drivetrain Horrible Noise Need Help!!

    Okay, the big issue is I'm not quite sure what is wrong with my car. I have a 2014 GT track pack and I have had it for about 6 months. I drive the car pretty conservatively I think. I mean I play arund in every now and then but by no means foot to floor every second person. Well the other day I...
  5. Sean_S197

    Clutch/flywheel Compatibility Question

    Hey folks, I have a 2008 Mustang GT with a 4.6l 3v with a 6-bolt crank (Romeo-built engine) I recently bought a McLeod Chromoly steel racing flywheel and wanted to know if there were any compatibility issues if I bought an Exedy clutch to pair with it. Does anybody have experience on using...
  6. S

    T45 In A Late 01-02 Mustang Gt?

    So my tremmec 3650 is going out in my GT at around 125k the cluster gear is rattling all over the place. I found a T45 local for a low price around 90k miles. Now I was wondering being an 02 would that transmission go right in? He said it's already been swapped out from mechanical speedo to...
  7. MoDriver

    SOLD 1998 Svt Mustang Cobra / 120k Miles T56 Magnum 6-speed

    1998 Mustang Cobra, black w/black leather interior, 6-speed manual transmission, Mach-460 AM/FM cassette, cruise control, and power seats. Located in Springfield, VA. Much of the mechanicals have been upgraded or replaced. The engine and paint is original and stock. This car now features a...
  8. Whammytap

    Engine Not Braking Between Shifts

    Hi all, I've got a 1979 Ford Fairmont and this is the closest thing I can find to a forum for my car. I heard there are a few Fairmont owners among you, and the Fairmont is a Fox. So I thought I'd introduce myself (well, introduce my car at least) and ask a question that has been troubling me...
  9. Benz510

    Drivetrain Transmission Leaking?

    Hey guys, So i have recently noticed that there may be a leak coming from my transmission since i have seen ATF on the undercarriage of my 89 Foxbody. I see no leaks or fluid on the ground when the car is parked up. Obviously it's coming out when the car is being driven. I notice it leaks on...
  10. FastDriver

    SOLD Tremec Tko 5 Speed Transmission With Accessories - $1500

    Sold
  11. Five.0GT

    Rotational Torque And Weight Transfer = Manual Transmission Shift Issues

    This may be a bit long, so bear with me. I have a 2016 Ford Mustang GT with 6-speed manual, non-PP. I have noticed on several other forums and even Edmonds.com and Road and Track (I believe) had articles dealing with complaints of Manual Transmission on the S550 ('15+) and even the prior...
  12. B

    Drivetrain Mustang T5 Overdrive Transmission Bolt Pattern

    I have an 01 3.8l V6 with a T5OD transmission and I am currently replacing the clutch. Does this have the same bolt pattern to the bellhousing as the standard T5 trans does? Can someone post a picture or link to a good view of the bolt pattern? Being able to see where these invisible bolts are...
  13. H

    Help! Engine Replacement, Now Throw Out Bearing??

    2003 Mustang Gt, 44k original miles and has been taken care of not ragged. It is modded with all the typical bolt ons and also has a procharger kit, long tubes etc. NO ISSUES PREVIOUSLY. So i was driving home and had a rod start knocking. so after i got the bad new i ordered a remanufactured...
  14. Frank289

    Pulling A Toploader From A 65 Coupe

    Hi all, My son and I are going to rebuild the 4 speed toploader in his 65 coupe. I've pulled it before with the bellhousing, but was wondering if just the transmission can be pulled? I'm thinking the only issue would be the throwout bearing. Anyone ever try this or have an opinion? I dont...
  15. B

    69 Coupe T56 Conversion

    I have a 69 coupe 351 w and a 4 speed top loader rear end geared at 3.89.1 and the 4 speed is killing me on the highway im wanting to swap out the transmission but im torn between the tko 600 and the t 56 id rather the t 56 because I wanna drive it on the highway and want the 2 overdrive gears...
  16. FrankenStang88

    Drivetrain Matching Spline Numbers

    My fox is in big need of a new tranny and differential, only problem is, the differential i need is 31 spline and the tranny i need is input 10 output 28. Am i going to need to spend some extra money to get the right ones? As it is im looking at 2k for both and cant really soend much more than...
  17. Benz510

    Clutch Cable.. Pedal Hard To Push In

    Hey all, Just purchased a '89 GT. This is my 3rd fox body. It has been a while since owning one so i'm kind of new to all of this again.The 91 i owned seemed to be the same but it had a centerforce in it and my 92 i owned seemed to be easier than this one. Anyways, The clutch pedal seems a bit...
  18. Nathaniel Donnelly

    Rebuild C4 Or Replace With C6

    Hello Stangnet! I've noticed the C4 in my '67 vert is starting to take a while to engage when cold. I realize that this may mean a rebuild to replace all the worn junk inside. Not sure of the history of the tranny, but suspect it has never been rebuilt. Right now, I have the numbers-matching...
  19. Nathaniel Donnelly

    Bad Vibrations! Help!

    I have a '67 vert 2v 289 with a C4. Engine was just rebuilt 5k miles ago, and runs great at slow speeds. However, once I get above 50 mph or so, the car begins to shake violently, but not always. Sometimes it's as smooth as an Audi. When it does shake, I can really feel it when I put...
  20. D

    Installing Mgw Shifter And Changing Trans Oil. Can I Do It In My Garage?

    Hi all, I'm from the UK and upgraded from my 05 V6 to a 2011 5.0 manual. Just waiting for it to arrive now. It's still running the stock shifter, and I can only imagine the stock trans fluid. I plan to buy an MGW shifter (as long as they will ship to me) and I've located some Amsoil MTF in the...