Back at it.
Cut about a 3.5” section of 2.5” stainless tube and tacked it onto the flowmaster tailpipes. Fit seems good. Once I get the other side in, I’ll mount the upper arms and mock up the PHB to check clearance. My only concern other that that is driveshaft clearance.
I think I can get the exhaust mostly installed but then will need to wait until axle is in place before permanently clamping it all in place.
However, so much easier to work with it missing right now.
On to the drivers side now.
Cut about a 3.5” section of 2.5” stainless tube and tacked it onto the flowmaster tailpipes. Fit seems good. Once I get the other side in, I’ll mount the upper arms and mock up the PHB to check clearance. My only concern other that that is driveshaft clearance.
I think I can get the exhaust mostly installed but then will need to wait until axle is in place before permanently clamping it all in place.
However, so much easier to work with it missing right now.
On to the drivers side now.