Kinda what I thought but wasn’t sure and then convinced myself otherwise LOL.No. The sensor ground is in the wiring itself.
if it was a 1 wire setup it would need to be grounded
Thanks! I’ll probably just roll with this for now till summer. Who knows if I’ll need to make any changes anyway. I didn’t think about cerakoting. I’ve sprayed many firearms with it but not the bake on finish I think I use H series. Can’t believe I didn’t think of it.KZ, if you're running into problems getting a standard temp across the intake, let Steve know. He knows how to get a hold of me. I don't know how low I can get my cerakote oven down to, but am willing to give it a try. Or, you could always just cerakote it and not worry.
Are they the same thread size as the Ford sensor?Looks like it will work out just fine. For the air temp sensor I highly suggest using a gm open element... they have a much faster response rate and IMO are more accurate.
Ok. I’ll pick up the GM sensor and swap out the Ford one. I do recall thinking the current sensor was a bit slow. I felt the change in temp especially when I know water/meth is being injected was delayed by a few seconds!Lol. Basically yes, the mat air density curve and blend curve. They are already tuned for that application however and should not need to be touched. I monitor intake temps and ambient temps fwiw
Oddly enough, I don't consider it enough myself. I'm stuck on wrinkle black, or straight VHT. Sad considering the H coat was originally intended for aviation and automotive parts.Thanks! I’ll probably just roll with this for now till summer. Who knows if I’ll need to make any changes anyway. I didn’t think about cerakoting. I’ve sprayed many firearms with it but not the bake on finish I think I use H series. Can’t believe I didn’t think of it.
Dont matter... its basically a resistor that changes value with temperature.@a91what which wire is which? Signal return etc...
sensor threaded right in with no issues, actually it fits better than the Ford one since it physically smaller.
Cobra booster ?That job was the biggest pain in my a** out of all I’ve done. The heater core was less of a pain.
Ya it was the worst LOL.Cobra booster ?
I just did that , I agree bigger pia than I imagined !
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?