what should i do???

jimc347

New Member
Sep 25, 2005
77
0
0
okay i picked up a 91 notchback. mods are tfs heads 1.7 rr, track heat upper and lower intake, stage 1 cam, 3:73 gears, 80mm c&l tube, 24# injectors cailerbrated. 70mm throttle body with spacer. 5spd tranny. long tube headers into flowmasters. the problem very doggy down stairs all upper rpm. how can i get more lower.
 
The stage 1 cam isn't really meant to give low-end power. IIRC, it comes alive around 2500 RPM, and coupled with 1.7 roller rockers, and the Track Heat intake, the mods you listed scream high RPM all over them. You're seeing roughly .530/.542 lift intake and exhaust respectively, so it probably also doesn't have a lot of velocity down low. I'm making this assumption based on the engine being the stock 302. Swapping back to 1.6 roller rockers alone would probably give you back some lower RPM power, but IMO, probably not a whole lot. With a power adder of some sort, you'd probably have a great combination as it sits, but for now, I think your lack of low RPM power is because of too much valve lift, and parts designed for power at higher RPM.
 
How is the tune? Whats your timing at? Do you have the right spark plugs in the heads? Sometimes guys make mistakes and put stock plugs in alum heads. I had that set up and it was fine down low.
 
yes i do have a standed plug but what should i use and what should i gap it at??? and it is a 302. i did not check timing but what should the base be set at?. also do i need a chip done for this setup?
 
Use autolite 3924's gapped around .050", set the base timing to 18*. 18* is the hot spot I found for TW heads. Anywhere from 16-20* should work. Use at least 89 gas.