Hi everyone,
just wanted to share a small update from our first-gen Mustang project.
We’ve been working through the car little by little and recently added a new bracing setup in the engine bay. It’s one of those details that doesn’t jump out at first, but fits in nicely with the rest of the build.
It’s an aluminum setup with steel hardware, and we tried to keep the whole installation as clean and natural-looking as possible.
I finally got a few decent installed photos of it on the car, so I thought I’d share them here.
How do you guys usually approach this area on 65–70 Mustangs — keep it fully stock, or make a few small changes as you go?
just wanted to share a small update from our first-gen Mustang project.
We’ve been working through the car little by little and recently added a new bracing setup in the engine bay. It’s one of those details that doesn’t jump out at first, but fits in nicely with the rest of the build.
It’s an aluminum setup with steel hardware, and we tried to keep the whole installation as clean and natural-looking as possible.
I finally got a few decent installed photos of it on the car, so I thought I’d share them here.
How do you guys usually approach this area on 65–70 Mustangs — keep it fully stock, or make a few small changes as you go?
